If you hear a static noise in the background, you need a ground loop isolator, like this one. Done - you should be able to hear whatever audio your phone it putting out via your PC's audio output, while still being able to listen to your PC audio, like Tarkov sounds. Then select your output device from the dropdown below, that's your headphones or speakers. Settings, Listen, check 'Listen to this device'. Then, go into Windows' Sound Control Panel, 'Recording' tab, find the Line In. Connect one end to the headphone port on your phone, and the other end to your PC's line in port. You need a male-to-male 3.5mm audio jack cable. joaomiguelneves2007 liked The Open Book.Use a voice chat app on your phone, and use the PC's line in to listen to it.abdennour liked Nyam Flash Loader STM32.Carlos liked Felini - Revolutionary Pocket-Sized Electronic Lab.Carlos liked CLN17: $15 BoM Closed-Loop Driver for NEMA17.Keith has added a new log for ZX81 logic in six SPLD chips, by Andy Rea.Carlos liked Crowdsourced Atmosphere Science & Student Rockets.STEVE BURKE on Ingenuity’s 62nd Flight And Attempting A New Speed Record.NERP!DontThinkSoNoThanks! on Hackaday Superconference 2023: Workshops Announced, Get Tickets Now!.None on This 3D Printable Soldering Air Filter Really Sucks.abb on How The 2022 CEZ Event Shows The Fragility Of Environmental Sensors In High-Risk Areas.Saddest zoomer of All Time on Meshtastic And Owntracks To Kick Your Google Habit.Tech In Plain Sight: Skyscrapers 3 Comments So why would you change it if it has more disadvantages than advantages? Theres also nothing wrong with 3.5mm analogue, and I can’t see any advantages to using USBC, especially since you usually want a separate audio output anyway. I also think USBC is probably weaker than a 3.5mm plug, and since cables tend to be pulled and yanked etc, then it maybe better staying with 3.5mm. You could use a USB hub but then the devices probably will show up as separate audio outputs on your device so you’ll need some extra software to output to all of them at the same time. I can’t see it being very easy to split a USBC audio signal, since USB is supposed to be between two devices and not split. Too many devices are still in use that use normal analogue headphones, most PCs still do, a lot of laptops do, etc, and it makes it very easy to connect in other devices like speakers or to split the signal.

It’s definitely nowhere near that time yet, I know phones have gotten rid of audio jack’s but look how many people complained about that.

Posted in Nintendo Hacks Tagged audio, Ground, Ground Loop, mixing, nintendo, pc, signal, switch, transformer Post navigation If you’ve never heard of a ground loop before, take a look at this guide to we featured a few years ago. It’s a great read if you’ve ever been stumped by a mysterious noise in a project. With that out of the way, the task of mixing the Switch audio with sources from other devices could finally proceed unimpeded.Īs an investigation into a nuisance problem, this project goes into quite a bit of depth about ground loops and carrying signals over various transforming devices. It took a few revisions, but eventually they settled on a circuit which improved sound quality tremendously.

set about solving the issue using an isolating transformer. When sending the Switch audio into a computer a loop like this formed. The low impedance path creates oscillations and ringing which is especially problematic for audio. Ground loops occur when there are multiple paths to ground, especially in wires carrying signals. was running into just this sort of frustrating problem while attempting to send audio from a Nintendo Switch into a PC, and documented some of the ways he attempted to fix a common problem known as a ground loop.

So much so that engineers can spend their entire careers specializing in grounding and bonding. Issues with proper grounding can be complicated, confusing, and downright frustrating to solve. Grounding of electrical systems is an often forgotten yet important design consideration.

Ground loop 3.5 mm